National Instruments Corporation NI PXIe-7965R NI FlexRIO FPGA Module (Virtex-5 SX95T, 512MB RAM)
- DSP-focused Virtex-5 SX95T FPGA programmable with the LabVIEW FPGA Module
- 512 MB onboard DDR2 DRAM
- Access to 132 single-ended I/O lines, configurable as 66 differential pairs
- Customizable I/O with the NI FlexRIO Adapter Module Development Kit (MDK)
- 16 DMA channels for high-speed data streaming at more than 800 MB/s
- Check Resources tab for compatible adapter modules
- Configure Complete PXI System
- View Data Sheet
View Support Resources
NI FlexRIO hardware provides flexible, customizable I/O for NI LabVIEW FPGA. It features two parts: NI FlexRIO field-programmable gate array (FPGA) modules for PXI and PXI Express and NI FlexRIO adapter modules that provide high-performance analog and digital I/O. Together, they form a reconfigurable instrument programmable with LabVIEW FPGA software.
The NI PXIe-7962R FPGA module features a digital signal processing (DSP)-focused Virtex-5 SX50T FPGA and 512 MB of onboard DDR2 DRAM. This FPGA incorporates 288 DSP slices, which you can use to implement digital filters, custom signal processing, and fast Fourier transform (FFT) logic, all of which are commonly found on analog FPGA-based instruments. In addition, the theoretical onboard DRAM throughput of 3.2 GB/s is necessary when operating on large data sets with the highest-performance adapter modules.
High-Performance Peer-to-Peer Streaming
Peer-to-peer streaming is a new technology from NI that enables direct data streaming among multiple FPGA modules, or between select PXI Express modular instruments and FPGA modules, without sending data back to the host processor. The new NI-STC3 application-specific integrated circuit (ASIC) provides this peer-to-peer data streaming at rates exceeding 800 MB/s (aggregate) on up to 16 separate streams. With this powerful feature, you can add FPGA capabilities to high-performance NI digitizers with NIST-traceable calibration or expand your FPGA algorithms across multiple FPGAs for computationally demanding applications.
Build Your Own I/O for LabVIEW FPGA
Use the NI FlexRIO Adapter MDK to build custom I/O to meet your exact application needs. The NI FlexRIO card edge connector offers direct access to the raw digital I/O pins of the FPGA. Each pin is capable of low-voltage differential signaling (LVDS) rates up to 1 Gbit/s and single-ended rates up to 400 Mbits/s.