National Instruments Corporation NI 9237 DSUB 4-Ch 50 kS/s/Ch, 24-Bit Bridge AI, Conformal Coated
The NI 9237 simultaneous bridge module for use with NI CompactDAQ and CompactRIO contains all the signal conditioning required to power and measure up to four bridge-based sensors simultaneously. The four RJ50 jacks provide direct connectivity to most torque or load cells and offer custom cable solutions with minimal tools. The high sampling rate and bandwidth of the NI 9237 offer a high-quality, high-speed strain or load measurement system with zero interchannel phase delay. With 60 VDC isolation and 1,000 Vrms transient isolation, the NI 9237 has high-common-mode noise rejection and increased safety for both the operator and test system.
The NI 9237 can perform offset/null as well as shunt calibration and remote sense, making the module the best choice for strain and bridge measurements.
The NI 9944 and NI 9945 are accessories for use with quarter-bridge sensors. These accessories have a female RJ50 connector on one end and screw terminals on the other end.
Recommended Accessories
-NI 9949 RJ50 to screw-terminal adapter (for RJ50 variant)
-RJ50 cable for NI 9944, NI 9945, and NI 9949; 2 m (for RJ50 variant)
-CB-37F-LP unshielded, I/O connector block with 37-pin D-SUB (for D-SUB variant)
Box Contents
-1 NI 9237 C Series module
-1 NI 9237 Operating Instructions and Specifications manual