National Instruments Corporation NI 9201 DSUB, +/-10 V, 12-Bit, 500 kS/s, 8-Ch AI Module
- 8 single-ended channels, 500 kS/s sample rate
- 10 V measurement range, 12-bit resolution
- 250 Vrms channel-earth, CAT II (screw terminal), or 60 VDC channel-earth, CAT I (D-SUB) isolation
- 25-pin D-SUB or 10-position screw-terminal connectors available
- -40 C to 70 C operating, 5 g vibration, 50 g shock
- Configure Complete CompactRIO or NI CompactDAQ System
- View Data Sheet
View Support Resources
The NI PCI-7813R digital reconfigurable I/O (RIO) board features a user-programmable FPGA chip for onboard processing and flexible I/O operation. You configure all functionality using NI LabVIEW graphical block diagrams and the LabVIEW FPGA Module. Your block diagram executes in the hardware, giving you direct, immediate control over all I/O signals to deliver high-performance capabilities such as the following:
-Complete control over the synchronization and timing of all signals and operations
-Custom onboard decision making that executes with hardware-timed speed and reliability
-160 digital lines individually configurable as inputs, outputs, counter/timers, PWM, flexible encoder inputs, or specialized communication protocols
With R Series digital RIO devices and LabVIEW FPGA, you can configure user-defined hardware for a wide variety of applications, such as custom digital DAQ, high-speed waveform generation, sensor simulation, hardware-in-the-loop (HIL) test, custom digital communications protocols, bit error rate testing, and other applications that require precise timing and control.
Recommended Accessories
The NI SHC68-68-RDIO cable is designed and shielded specifically for the digital I/O (DIO) connectors on R Series digital RIO devices for improved signal integrity when connected to terminal blocks or the NI 9151 R Series expansion chassis.